G1000 through G2000 Series Installation Instructions

Model G1000 Installation Instructions

  1. A) Position the guide straps at the applicable support location as shown.
  2. A) Install the bolt through the top ears of the straps and hand tighten nut until snug tight.

Model G2000 Installation Instructions

  1. A) Position the guide straps at the applicable support location as shown.
  2. A) Install the bolts, nut and spring nut as shown. Hand tighten nut and bolt until snug tight.
  3. A) Install the bolts through the top ears of the straps and hand tighten nuts.B) Install the bolts through the top ears of the straps and the spring nuts and hand tighten until snug tight.

Note:

Provide 1/16″ radial clearance all around between the shield and the strap except at the bottom as shown in Figure 1 and Figure 2.
Top