Pipe Shields

   Manufacturers of insulated pipe supports, hot shoes and cold shoes since 1971

Loading
 
Call Us: (800) 538-7007   Se habla español
 

 
 

Pipe Shields G1000 through G2000 Series Installation Instructions

Model G1000 Installation Instructions

  1. A) Position the guide straps at the applicable support location as shown.

  2. A) Install the bolt through the top ears of the straps and hand tighten nut until snug tight.


Model G2000 Installation Instructions

  1. A) Position the guide straps at the applicable support location as shown.

  2. A) Install the bolts, nut and spring nut as shown. Hand tighten nut and bolt until snug tight.

  3. A) Install the bolts through the top ears of the straps and hand tighten nuts.

    B) Install the bolts through the top ears of the straps and the spring nuts and hand tighten until snug tight.


Note:

Provide 1/16" radial clearance all around between the shield and the strap except at the bottom as shown in Figure 1 and Figure 2.

 

 

Parent Company: Piping Technology: Pipe Supports, Pipe Clamps, & Pipe Hardware
Fellow Subsidiaries
U.S. Bellows: Metallic & Fabric Expansion Joints, Bellows
Sweco Fab: ASME Vessels, Pig Launchers, Spectacle Blinds

Pipe Shields: Pre-Insulated Pipe Supports, Slides, Guides & Anchors
Fronek Anchor/Darling
: Snubbers, Sway Struts & Sway Braces
Contact Us: 707-447-5014 Toll Free1-800-538-7007. info@pipeshields.com

Copyright 2017 Pipe Shields, Inc. All Rights Reserved. Contact Us | Privacy Policy