Pipe Shields

   Manufacturers of insulated pipe supports, hot shoes and cold shoes since 1971

Loading
 
Call Us: (800) 538-7007   Se habla español
 

 
 

Pipe Shields D4000 through D5000 Pre-Insulated 2 Rod Hanger Installation Instructions


D4000-D5000 PAGE 1_1


D4000-D5000 PAGE 1_2

D4000-D5000 PAGE 2_1

D4000-D5000 PAGE 2_2
                           Figure B

Installation Steps

  1. A) Position the bottom half of the insulated hanger shield (insulating structural material and sheet metal jacket) on the pipe at the desired location as shown.


    D4000-D5000 PAGE 1_3




  2. Gently slide into position the top half of the insulated hanger shield over the bottom half shield as shown.



  3. Note: When models include heat trace groves, the number and location may vary. Check with design drawings for exact number and location. Ensure that the heat tracing cable is properly positioned inside the grove of the shield.


  4. A) Position straps between the beads.

    B) Install the threaded rod (by others), lockwashers and nuts and hand tighten. 

    C) Apply torque on the bolts.

    D) Select torque value that correspond with the pipe size and model designation of the unit shown on Table 1.Below when tightening, it is recommended that the bolts are cross torqued until the required torqued has been achieved to obtain an even pressure on the structural insulation.

    E) To ensure that the bolts are properly cross-torqued by checking spacing "B" between the ears shall be approximately the same (see Figure B).

 

Table 1
Bolt Torque
  D4000 Series D5000 Series
Pipe Size Bolt Torque
(FT-LBS)
Bolt Torque
(FT-LBS)
1/2" 1-3 1-3
3/4" 1-3 1-3
1" 1-3 1-3
1 1/4" 1-3 1-3
1 1/2" 1-3 1-3
2" 2-4 2-4
2 1/2" 2-4 2-4
3" 3-5 3-5
3 1/2" 3-5 3-5
4" 3-5 3-5

 

 

Parent Company: Piping Technology: Pipe Supports, Pipe Clamps, & Pipe Hardware
Fellow Subsidiaries
U.S. Bellows: Metallic & Fabric Expansion Joints, Bellows
Sweco Fab: ASME Vessels, Pig Launchers, Spectacle Blinds

Pipe Shields: Pre-Insulated Pipe Supports, Slides, Guides & Anchors
Fronek Anchor/Darling
: Snubbers, Sway Struts & Sway Braces
Contact Us: 707-447-5014 Toll Free1-800-538-7007. info@pipeshields.com

Copyright 2017 Pipe Shields, Inc. All Rights Reserved. Contact Us | Privacy Policy